Bizfon 7000 User's Guide download pdf (Page 20)

System Administration Guide Adding Handsets

50 Stiles Road • Salem, NH 03079 • Toll Free 1-800-260-5793 • 603-870-9400 • www.Bizfon.com

Revised: August 5, 2005 Page 16

Select the phone model and fill in the required fields.

If the phone isn’t an Bizfon IP2 or one of the recognized Cisco phone types, then follow these steps:

1. Change the Model to Generic SIP.

2. Enter a Login ID and Password for the phone to use to authenticate with the server. Note that the Login

ID must be unique; cannot use the same Login ID on multiple phones.

3. Click the Program button to add the new handset to server.

4. Configure the phone (following its particular configuration instructions) with the User ID (shown on the

updated Phone System / Handsets page), Login ID, and Password.

If the phone is one of the supported plug-and-play types, then follow these steps:

1. Change the Model to the appropriate selection for the phone to be configured.

2. Enter a Login ID and Password for the phone to use to authenticate with the server. Note that the Login

ID must be unique; cannot use the same Login ID on multiple phones.

3. Enter the correct MAC Address for the phone. Note if this isn’t correct, then when the phone is booted on

the network, the server will have a duplicate entry for this phone (because it will plug-n-play register itself

with the system at the correct MAC address).

4. Enter the other parameters as necessary.

5. Click the Program button to add the new handset to server.

When the phone is registered with the server, its entry on the Handsets page will indicate that.

6.2 Analog Phones

Plug the phone into one of the server’s phone ports reserved for Inside Phone Extensions. It is a good idea to

plug the first phone into port 16, the next one into port 15, etc., working backwards toward port 4. Lift the

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 75 76

No comments

Bizfon 7000 User's Guide Page 20