Bizfon 7000 User's Guide download pdf (Page 50)

System Administration Guide Remote IP Phone

50 Stiles Road • Salem, NH 03079 • Toll Free 1-800-260-5793 • 603-870-9400 • www.Bizfon.com

Revised: August 5, 2005 Page 46

As instructed on the page, enter the firewall’s public internet address as the Public IP Address. Furthermore,

the firewall must be configured to statically map specific ports through the firewall to the Bizfon server. This is

described in the NOTE section on the page.

12.3 Remote Bizfon IP2 Phone

12.3.1 Configuration

Configuration of the remote phone requires setting two configuration parameters in the phone itself. Both are

found in the Config / Network Settings menu on the phone.

The first is Boot Server IP. This is normally the IP address of the Bizfon server’s WAN port which can be

obtained from the server’s WAN TCP/IP Address parameter on the Network / Configuration page. However,

if the Bizfon server network mode is set to LAN Host, then this value will be the Public IP Address parameter

on the Network / Configuration page.

The second is Remote Plug and Play Key (called Remote Plug ‘n’ Play on the phone menu). This key is

also obtained from the Bizfon server. Go to the Servers / VOIP Server page. You will see a page like this:

The Plug ‘n’ Play Secret Key is what should be entered into the phone.

After entering these two parameters into the phone, save the settings (the phone will automatically prompt you

to do that when you exit out of the configuration menu) and then reboot the phone.

At this point the remote phone generally operates the same as any other phone on the server’s LAN.

TIP: If this doesn’t seem to work, restore the phone’s factory defaults and re-apply the required settings.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 75 76

No comments

Bizfon 7000 User's Guide Page 50