Bizfon 7000 User's Guide download pdf (Page 57)

System Administration Guide Call Routing

50 Stiles Road • Salem, NH 03079 • Toll Free 1-800-260-5793 • 603-870-9400 • www.Bizfon.com

Revised: August 5, 2005 Page 53

Most of the configuration options on this page should be comprehensible after reading the Call Routing

Concepts section above. Some additional explanation follows.

Notice the presence setting displayed near the top of the page. Next to it is a checkbox to apply changes

made here to all presences. If this call route has no CallerID pattern specified (it is the “all calls” call route),

then this call route is copied to the “all calls” call route in all the other presences. If this call route has a

CallerID pattern specified, it is copied to the same CallerID patterned call routes in the other presences,

creating new call routes if necessary.

To delete a phone from a connection attempt, choose “no selection” from the call appearance drop down list.

To set up a connection attempt so it properly participates in the ringing of a line appearance PFK on an Bizfon

IP2 phone, select “Key System Ring Delay” from the call appearance drop down list. See XXX for more

information.

Recall that the on-busy route is optional. An inactive on-busy route is one with no connection attempts and a

finally clause set to Hang up. To make it active, add one or more connection attempts and/or change the

finally clause. To make it inactive again, just change it back to the inactive state (delete all connection

attempts and set the finally clause to Hang up).

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 75 76

No comments

Bizfon 7000 User's Guide Page 57